Does your old flooring or carpet need a new look? Looking for an inexpensive and modern solution that’s easy on the eye?

Floating floors allow you to carry out the installation on practically any surface.

Floating floor systems remove the headaches caused by the more conventional flooring options. Floor preparation is usually limited, and you are delivered a faster installation than other hard wood systems. There is also no need to install battons or plywood Traditional flooring can often cost twice the price.

There are many reasons why this product is so popular. There are various options offering versatility for commercial and domestic use. The commercial and domestic markets offer substantial selections of both modern and traditional colours and designs.

Installation of Your Vinyl Floating Floor Estimating the correct required amount of materials is crucial.

Floating floors are quite adaptable. In most cases you can successfully install your new floor directly over the top of the existing vinyl, timber, or concrete floor. The beauty of the floating floor product is to camouflage nearly any minor abnormalities with your old surfaces. However always eliminate any bumps or large cracks before the installation. Ascertain moisture. If you are unable to access a moisture meter, use a small section of the vinyl floating floor and place it in the appropriate area for at least 24 hours so you can detect moisture problems. As a precaution, always loose lay a plastic barrier directly to the existing floor. For more advice on this, travel to your local carpet Brisbane outlet.

By this stage, it’s time to carry out the installation. After the plastic is secured you can commence the installation of the underlay foam. Before you start laying the actual panels, it’s advised to leave .5 of an inch distance from the wall. Use spacers to maintain expansion consistency. Determine the furthest distance from the main doorway then commence laying. Make sure the floor groove side faces the wall. Apply small amounts of wood glue in the panel grooves tapping gently with your rubber mallet. For large open spaces, ensure to allow for expansion provisions every 30 linear feet. Utilize an appropriate manufacture standard joint sealer.